tom hardy venom 1/12 head sculpt Preorder product will be shipped within 10 Day This is a handmade. it is a resin and Finished paint The head holder hole is wide for 1/12 figure. it is not fit. It made for marvel legends venom and marvel select venom or up to you You can use patafix pro power to help you put on your head. ( Free in the box ) custom head tip and trick Head insertion 1. Use UHU patafix because we can still swap the head with other BODY. 2. Use an epoxy sculpture to adjust the hole size to match the joint’s head.Recommended to follow this clip.https://youtu.be/m5YPr73I6bk 3. rubber tube or water pipe tap ( many way it made joints bigger ) There are two methods of removing the figure head. Method 1: Using a hot dryerBlow around the head to distribute heat on all sides.Use your hand to pull it out, if it doesn’t work, don’t force it. heat it up again.And doing this repeatedly, it will be removed. Method 2: Use hot waterPrepare water in a ceramic mug. If there is a microwave, take into microwave or heat water from an electric kettleDip your head in and soak for 40-60 seconds, depending on the type of plastic.Then pull it out. If it doesn’t work, don’t force it. Dip your head in hot water again. Do this over and over and it will remove it. noteIn the case of a soft-necked joint figure, hot water should not be allowed to touch the neck.Dip only the head and pull it. Keep doing this.Dip for about 1 minute. Take for example the TOYBIZ tobey Spider-Man figure. After removing the head We want to take it in and out easily. Should polish the head hole wider.How to polish the head hole 1. sandpaper. Wrap the stick and spin it around. but it will be slow2. Mini Electric Grinder. There are many models depending on budget. Note: Loose joints action figure, don’t forget KIKI for loose solution.