KiKi Fix Loose Jionts ( How to open the cap : Press and turn counter clockwise. ) Fixing loose Jionts action figure has never been so easy!Use Kiki on : Dc universe hasbro, mattel, shf figureart, marvel legends, Tranformers, MAFEX, marvelselect, hottoys, mezco, Saint Seiya,Neca, McFarlane, SIC, GUNPLA,WWE, Barbies starwars, and so much more The new kiki bottle it have 2 head cap.you can swap head 1.plastic cap 2.needle capNo problem with the needle cap Block again. if you Should washing the needle cap with water after every use KiKi’s Highlights * Can coat* Precession needle applicator.* Thin enough to seep joints.* Water base non toxic* will not harm your figure* slow drying ans semi flexible ( Water base )* Dries clear KIKI work on all type of phastic and die-cast. it is easy to appy and a little goes a long way. Application instructions and tipCoating and dropping are the two ways KiKi can be applied. For coating a joint ( like a ball joints ) allow Kiki to dry for at least one hour.( Recomend 3 hours or It would be great if Kiki to dry 6-7 hours.and The drying time depends on the amount of KIKI solution that you drop.) You can recoat as many time as you like to get the desiredeffect. Some plastics like shf many take longer to dry than others. For dropping Kiki only use small single drops into the jiont. Movie jiont every few minutes while drying as to not seize the joint.Work best with pinned jionts and soft ratchets For heavy figures allow 24 hour to dry before moving jiontsThe dispensing needle get clogged quickly. Use the provided pin to unlog if you forget move first time joints more than 48 hour. joints can not move. please use hot gun or hot water to help. and move slow stored at room temperature between 10° to 26°C tip : If any part of the model is easy to fall off. Drop some a little kiki and wait dry if you want to remove it just heat