*Figures not included PLEASE NOTE: This item is now unfinished. That means the 3D print supports are still attached and will need to be removed by the buyer. See pictures with supports attached. Best way to clean up is to use a pliers for the claws (start in the center) and big supports on the tentacles to carefully remove the supports, then use a Dremel sanding drum or sandpaper for a finer finish. The price has also been lowered to reflect the new condition. Marvel Doctor Octopus – Doc OckSpier-Man villanMEGO scale. 8″ 1:9These tentacles are made for Mego size (8″ 1:9 scale) action figures Accessories include: Back Sockets/ Anchors4 Tentacles4 clawsExtra tentacle parts to create your own tentacle configuration. Certain tentacle configurations will allow Doc Ock to stand using the tentacles. * tentacles are articulate and rotate at the connection points. To remove tentacle segments, align the connection point tabs before pulling apart. See pictures. Do not bend when inserting or removing, align tabs and pull straight out. Drilling and gluing required for the Back Sockets. The tentacles connect into the supplied back sockets that have to be attached to the action figure. Use a 23/64″ drill bit and the sockets will fit snugly. Use modeling glue or UV liquid resin to attach Back Sockets into holes in figure. Items were 3D modeled and printed by me.Please note: I print the accessories and remove the supports. This can leave a rough edge on an item. In this case, along the edges of the tentacles. See pictures. *Free shipping